User's Manual

Radio Frequency Compliance Statement
IDENTEC SOLUTIONS is the responsible party for the compliance of the following devices:
MODEL:
i-MARK
Region/Country
Organization
Marking
EUROPE:
EC
CE
USA:
FCC
FCC ID: OO4-ILR-IMS350
Canada:
Industry Canada
IC: 3538A-IMS350
The user(s) of these products are cautioned to only use accessories and peripherals approved, in advance,
by IDENTEC SOLUTIONS. The use of accessories and peripherals, other than those approved by IDENTEC
SOLUTIONS, or unauthorized changes to approved products, may void the compliance of these products
and may result in the loss of the user(s) authority to operate the equipment.
European Notification according R&TTE Directive
This equipment complies to Art. 6.4 of R&TTE Directive (2014/35/EU, 2014/30/EU, 99/5/EC [expires on
June, 12
th
2016] and 2014/53/EU [valid from June, 13
th
2016]). It is tested for compliance with the
following standards: EN 300 220-1, ETSI EN 300 220-2, ETSI EN 301 489-1, ETSI EN 301 489-3, EN
60950-1:2006 + A11:2009 + A1:2010 + A12:2011
USA Notification
This device complies with FCC and Industry Canada RF radiation exposure limits set forth for general
population (uncontrolled exposure). This device must not be collocated or operating in conjunction
with any other antenna or transmitter. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Canada Certification
This device complies with Industry Canada’s license exempt RSS’s. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Le présent appareil est conforme aux CNR d‘Industrie Canada applicables aux appareils radio exempts
de licence. L‘exploitation est autorisée aux deux conditions suivantes:
(1) l‘appareil ne doit pas produire de brouillage, et
(2) l‘utilisateur de l‘appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d‘en compromettre le fonctionnement.