User's Manual

i-MARKInstallation and Hardware Manual

Page 14 of 22

3.2.4 Daisy Chain Connectors

To Master RJ 45 connector to the Host computer or the Slave port of the previous i-MARK in the

Daisy Chain.

To Slave RJ 45 connector to the Master port of the next i-MARK in the Daisy Chain. Leave this

connector open at the last device in the chain.

View into the connector = crimp/solder side of plug

To Master To Slave T568B color Description

1 RxD+ TxD+ White/orange

2 RxD– TxD– Orange

3 TxD+ RxD+ White/Green

4 V+ (10 … 30V) V+ (10 … 30V) Blue Power supplied over bus

5 V+ (10 … 30V) V+ (10 … 30V) White/Blue Power supplied over bus

6 TxD– RxD– Green

7 GND GND White/Brown Power supplied over bus

8 GND GND Brown Power supplied over bus

As the TxD/RxD crossing is done on the i-MARK only straight-through cabling has to be used between

i-MARKs.

Connection parameters

Signal levels: RS422

Baud rate: 115200 bits per second

Data bits: 8

Stop bits: 1

Parity: none

Mode: full duplex