User's Manual

Document # 7000-0001, Rev. A - 7 –
2.0 Configuration
The i-D2 tag requires no special configuration. Options are configured at the factory. It is
controlled by commands from the ILR Interrogation device.
3.0 Mounting the Tag.
3.1 Industrial Tag
The industrial tag is designed with two mounting holes so it can be firmly mounted onto
virtually any surface. It can be mounted using various methods dependent on the
particular application.
Among the common types of mounting are:
• Screws
• Rivets
• Double sided tape
Note: Mounting hardware is not supplied with the tag.
3.2 Personnel Tag
The personnel tag is designed with only one mounting hole so a chain or clip device (not
supplied) worn by an individual can be used to hold the tag.