User's Manual
i-CARD CF – User’s Guide
Version 1.2 26.07.2006 Page 7/10
2.0 Installation
The
i-CARD CF is easy to install—simply attach the antenna, insert the i-CARD CF into the desired computer (if
necessary use a standard PCMCIA – CF adapter) and install the necessary hardware driver for the specific
operating system. The following sections describe each of these steps in detail.
Note: The hardware driver only needs to be installed the first time an i-CARD CF is inserted into
a computer or when performing an upgrade to the driver.
2.1 Hardware
To install the external antenna, grasp its base and insert it into the antenna connector until it locks into place.
Figure 2: Antenna Installation
To remove the antenna, grasp the base firmly and remove carefully to avoid damage.
2.2 Software
The computer being used for i-CARD CF operations must be running one of the following operating systems:
Windows 2000/XP.
To install the i-CARD CF, perform the following steps:
1. Insert the
ILR
®
Installation Disk (either floppy disk or CD) into the computer that will operate the
i-CARD CF.
2. Insert the i-CARD CF into the CF card slot of the desktop or laptop computer.
An installation wizard will start immediately after the i-CARD CF is inserted.
3. Complete the wizard instructions
Note: A
readme.txt
file is available for each operating system on the
ILR
®
Installation Disk and
contains the same instructions that are described in the following sections.