User's Manual

i-CARD CF-350
Page 9 of 15
3 Installation
The i-CARD CF-350 is easy to install—simply attach the antenna, insert the i-CARD CF-350 into the
desired computer (if necessary use a standard PCMCIA-CF adapter) and install the necessary
hardware driver for the specific operating system. The following sections describe each of these steps
in detail.
Note
The hardware driver only needs to be installed the first time an i-CARD CF is inserted into a computer
or when performing an upgrade to the driver.
3.1 Mechanical Installation
To install the external antenna, grasp its base and insert it into the antenna connector until it locks
into place.
Figure 2: Antenna Installation
To remove the antenna, grasp the base firmly and remove carefully to avoid damage.
3.2 Driver Installation
The computer being used for i-CARD CF-350 operations must be running one of the following
operating systems: Windows 2000/XP.
To install the i-CARD CF-350, perform the following steps:
1. Insert the ILR
®
Installation Disk (either floppy disk or CD) into the computer that will operate the
i-CARD CF-350.
2. Insert the i-CARD CF-350 into the CF card slot of the desktop or laptop computer.
An installation wizard will start immediately after the i-CARD CF-350 is inserted.
3. Complete the wizard instructions
Note
A readme.txt file is available for each operating system on the ILR
®
Installation Disk and contains the
same instructions that are described in the following sections.