User's Manual

Installation and Operation Manual
Page 8 of 10
3 Tag Mounting And Initial Operation
The tag is equipped with a factory pre-set software, that takes up its job automatically whenever the tag is
attached to a bottle neck. When out of use the tag can be switched off with a handling procedure. Therefore
no configuration is needed in order to operate the tag.
3.1 Mounting And Switching The Tag On
The tag is mounted onto the neck of a bottle
After the tag is attached to a bottle it automatically takes up its custom-specific pre-programmed monitoring
of the bottle position. Therefore it sends out small data packages regularly and burst different short data
packages whenever the bottle changes its position.
3.2 Shutting Off The Tag
For shipping, transportation and long term storage the tag has the possibility to bring it into a dormant mode.
If the tag is simply removed from the neck of the bottle it will still remain active sending out a status
message.
The dormant mode is activated by a special sequence:
• Start a pour and tilt the bottle horizontally
• Wait about 4 seconds
• Detach the tag while the bottle is still horizontal.
The tag is automatically switched on again after it is re-mounted to the neck of a bottle.
Push the tag onto the neck of a
bottle.
The orientation has to be so, that
the label on front can be read in
storage position for best appearance.