ILR i-B350 BM Tilt Beverage Measuring ILR Tag Installation and Operation Manual
Installation and Operation Manual Proprietary Notice This document contains confidential information proprietary to IDENTEC SOLUTIONS and may not be used or disclosed to other parties in whole or in part without prior written authorization from IDENTEC SOLUTIONS.
i-B350 BM Tilt, ILR Tag Radio Frequency Compliance Statement IDENTEC SOLUTIONS is the responsible party for the compliance of the following devices: MODELS: i-B350 BM Tilt /NA, i-B350 BM /NA, i-B350 BM Tilt /EU, i-B350 BM /EU Region/Country Organization EUROPE: EC USA FCC Canada Industry Canada Marking CE FCC ID OO4-ILR-IB350BM IC:3538A-IB350BM The user(s) of these products are cautioned to only use accessories and peripherals approved, in advance, by IDENTEC SOLUTIONS.
Installation and Operation Manual Contents 1 INTRODUCTION ...........................................................................................................5 1.1 1.2 1.3 1.4 1.5 1.6 1.7 1.8 Preparations............................................................................................................. 5 Recommended Procedure.......................................................................................... 5 Scope of this Document .................................................
i-B350 BM Tilt, ILR Tag 1 1.1 Introduction Preparations This installation manual must be read carefully prior to starting the installation. The described installation works assume that installation materials like cable, antenna and tag holder etc are available. 1.2 Recommended Procedure 1. 2. 3. 4. Check the Scope of Delivery according to the Bill of Delivery Read this manual completely Mount the tags An additional performance check of the tags and a system test can now be done 1.
Installation and Operation Manual 2 Safety Precautions Important Safety Note The devices described in this manual is for exclusive operation by trained employees. Only qualified personnel that know the potential dangers involved should perform the installation, settings, maintenance and repair of the units used.
i-B350 BM Tilt, ILR Tag Spare Parts We recommend that only original products, spare and replacement parts authorized by IDENTEC SOLUTIONS be used for installation, service and repair. Otherwise IDENTEC SOLUTIONS does not accept any responsibility for materials used, work carried out or possible consequences.
Installation and Operation Manual 3 Tag Mounting And Initial Operation The tag is equipped with a factory pre-set software, that takes up its job automatically whenever the tag is attached to a bottle neck. When out of use the tag can be switched off with a handling procedure. Therefore no configuration is needed in order to operate the tag. 3.1 Mounting And Switching The Tag On The tag is mounted onto the neck of a bottle Push the tag onto the neck of a bottle.
i-B350 BM Tilt, ILR Tag 4 4.1 Maintenance General In principle, the ILR system is maintenance-free. When correctly installed it operates for many years without any problems. 4.2 Regular Cleaning of The Surface Remove dust with a brush or compressed air. In case there are fatty or oily substances use a soft cloth moistened with mild rinsing agent. Warning Do not clean the tag in a dish washer. Do not sandblast the tag. 4.
Installation and Operation Manual 5 Technical Data RF Characteristics Frequency Modulation Range Output power Protocol, compatibility 919.0 MHz (NA version) or 868.
