User's Manual

i-B2 S – User’s Guide
Version 1.0 03.08.2006 Page 11/12
C.3 Taping (on metal surfaces)
The following double-sided tapes from 3M are currently being used/recommended:
• On level, flat surface: 3M acrylic foam tape #5952 F (Temperature: 120°C [248°F], short-term at 150°C
[300°F])
• On uneven, slightly curved surface: 3M acrylic foam tape #4959 F (Temperature 150°C [300°F], short-term
at 204°C [368°F])
Dimensions
• On the roll: 50m (164 feet)
• Width: 19mm (3/4 inch)
• Thickness: 1.1mm (0.043 inches) for #5952 or 3.0mm (1/8 inch) for#4959
• Length: max. 130mm (5 1/8 inches) – cut to length
Procedure
• Preparation of surfaces:
- Plastic casing: preliminary cleaning, 3M Primer 26 GZH, 2 minutes waiting period
- Metal surface: preliminary cleaning, 3M Primer 86 A, 15 minutes waiting period
• First attach tape to tag bottom and press on with the roll
• Then attach the tag to the prepared metal surface
Important Information:
(1) Before using the tape, cleaning agents and primers as listed, need to check if these are compatible with
the customer’s operating conditions. The customer’s approval must be obtained.
(2) Metal surfaces in direct proximity to the tag can reduce the tag’s range of function. Tags should therefore
not be mounted in metal recesses or corners.
(3) After mounting, the tag’s function should be tested, i.e. with a handheld.
Double-sided
Tape