User's Guide

_________________________________________________________________________
Document #7201-003, Rev B Page 9
3.0 Using Your RFID Hardware
Now that your RFID system has been professionally installed, setup, and tested, the
following section will provide you with user interface diagnostic descriptions and
maintenance tips to ensure your RFID system will operate trouble free.
3.1 LED Displays
Status LEDs:
a) POWER: Lights when power is applied to the i-PORT
b) RUN: Blinks (every 2 seconds) as soon as the i-PORT has booted (approx. 10
seconds after power-up)
c) HOST: Lights when a host is connected to the i-PORT
d) ERROR: Lights when an error occurs (see section: Troubleshooting)
COM LEDs:
a) RX: Lights when the i-PORT receives data on serial interface
b) TX: Lights when the i-PORT sends data on serial interface
INPUT LEDs:
a) 1-4: Light when Inputs 1-4 are set (Connection to Ground)
NOTE: This functionality has not been implemented at this time.
ANTENNA LEDs:
a) 1-4: Light when there is activity at corresponding Antennas 1-4
Green: Antenna is sending
Red: Antenna is receiving (Orange to red, depending on the strength of
the signal
b) W: Lights when there is activity at the Wake-up Antenna
OUTPUT LEDs:
a) 1-4: Light when the corresponding Outputs 1-4 are set
NOTE: This functionality has not been implemented at this time.