User's Guide

_________________________________________________________________________
Document #7201-003, Rev B Page 10
Cable Connections and Plug Allocation
Depending on your project requirements, the installer of this device will have wired one or
more input and output devices. The following will describe the operation of each terminal
block employed on the i-PORT III.
Antenna jacks:
ANT1-4: SMA sockets, send and receive antennas
ANT W: SMA socket, send antenna ONLY (WakeUp Antenna, for i-Q tags only)
Terminal Block 1: +10-30V Connection for power supply (10-30V DC) Supply
GND Connection for power supply (GND) Supply
Terminal Block 2: Functionality has not been implemented at this time.
Terminal Block 3: Functionality has not been implemented at this time.
Terminal Block 4: Functionality has not been implemented at this time.
Serial and Ethernet Interface:
RS 232 interface (up to 115 kb/s) (for setup and diagnostics only) and Ethernet interface
(10 / 100 Mbit/s)