User's Manual

i-CARD User’s Guide
_____________________________________________________________________________________
Document # 7007-0001, Rev B - 9 –
3.2.3 Windows NT
To perform the following steps, administrator rights are required because you will
need to modify your machine’s registry.
On the ILR® Installation Disk, go to the \drivers\WindowsNT folder, and double-
click on the icard.reg file. The following dialogue box appears:
Click OK, then copy the icard.sys file from the \drivers\WindowsNT folder to the
\Winnt\system32\Drivers folder on the computer operating the i-CARD.
Remove the floppy disk and reboot the computer. The following screen appears
during startup:
Select the Startup Type of the i-CARD device. The Startup Type will vary from user
to user depending on the type of PCMCIA software installed. By default, Windows
NT does not support plug-and-play devices, therefore the Startup Type should be
set to Automatic. If you have additional software that permits plug-and-play
devices, then the Startup Type should be set to Manual.
If the above screen does not appear, go to Control PanelàDevices and select the
Icard device, click Startup, then click Close.
The hardware driver installation is now complete.