User's Manual

i-CARD User’s Guide
_____________________________________________________________________________________
Document # 7007-0001, Rev B - 6 –
3.0 Installation
The PC i-CARD is easy to install—simply attach the antenna, insert the i-CARD into the
desired computer and install the necessary hardware driver for the specific operating
system. The following sections describe each of these steps in detail.
Note: The hardware driver only needs to be installed the first time an i-CARD is
inserted into a computer or when performing an upgrade to the driver.
3.1 Hardware
To install the external antenna, grasp its base and insert it into the antenna connector
until it locks into place.
Figure 2: Antenna Installation
To remove the antenna, grasp the base firmly and remove carefully to avoid damage.
3.2 Software
The computer being used for i-CARD operations must be running one of the following
operating systems: Windows NT/98/ME/2000/CE.
To install the i-CARD, perform the following steps:
1. Insert the
ILR® Installation Disk (either floppy disk or CD) into the computer
that will operate the i-CARD.
2. Insert the i-CARD into the PC card slot of the desktop or laptop computer.
An installation wizard will start immediately after the i-CARD is inserted.
3. Complete the wizard instructions and refer to the following sections for additional
instructions specific to each operating system:
For O/S: Go to section:
2000 3.2.1
98 3.2.2
ME 3.2.2
NT 3.2.3
CE 3.2.4
Note: A readme.txt file is available for each operating system on the
ILR®
Installation Disk and contains the same instructions that are described in the
following sections.