User's Manual

MorphoAccess® SIGMA Extreme Series - Installation Guide
Identity & Security
Section 6 :Accessories, Software Licenses and PC Applications
58
This document and the information therein are the property of Safran Identity & Security.
They must not be copied or communicated to a third party without the prior written authorization of Safran
2017_2000024418 - Draft
V0
January 2017
Compatible PC applications
MorphoAccess® SIGMA Extreme Series terminals are fully compatible with:
 MorphoManager (version 10.3.4 or higher)
 Morpho Integrator’s Kit (MIK) software development kit (version 6 or higher).
 MorphoBioToolBox (version 3.4.3 or higher)
Using Legacy Morpho mode, MorphoAccess® SIGMA Extreme Series is also
compatible with:
 MEMS (version 7.3.1 or higher),
 MIK (version 5.4 or higher),
The limitations in Morpho Legacy mode are described in the following document:
MorphoAccess® SIGMA Extreme Series Release Note - Legacy Morpho limitations