User's Manual

MorphoAccess® SIGMA Extreme Series - Installation Guide
Section 4 : Electrical Interface
Identity & Security
2017_2000024418 - Draft
V0
January 2017
This document and the information therein are the property of Safran Identity & Security.
They must not be copied or communicated to a third party without the prior written authorization of Safran
45
Ethernet connection
Ethernet interface can be used to power the MorphoAccess® SIGMA Extreme Series
terminal through POE (Power Over Ethernet - IEEE802.3af or IEEE802.3at type 1
mode). According to the POE standard two modes are available: power on data pins
and power on dedicated pins.
Use either one of these modes depending on POE implementation on your local
Ethernet network.
Wi-Fi™ dongle must not be used with POE power supply. The POE doesn’t
provide enough power for both the terminal and the Wi-Fi USB dongle.
Ethernet cable shall be shielded
Default Ethernet configuration
By default, MorphoAccess® SIGMA Extreme Series terminal is configured in STATIC
mode with the following configuration : IP Adress : 192.168.1.10; Gateway Adress :
192.168.1.254; Subnet Mask : 255.255.254.0
Recommendations for RJ45 wiring
Pin
1
2
3
4
5
6
7
8
Signals
Data
pair 1
Data
pair 1
Data
pair 2
NC/POE pin
dedicated (+)
NC/POE pin
dedicated (+)
Data
pair 2
Ground/ pin
dedicated (-)
NC/POE pin
dedicated (-)
EIA / TIA T568B
Colors
White
orange
Orange
White
green
Blue
White blue
Green
White brown
Brown
EIA / TIA T568A
Colors
White
green
White
green
White
green
White green
White green
White
green
White green
White green
Corel L120 Colors
Grey
White
Pink
Orange
Yellow
Blue
Purple
Brown
Figure 23: RJ45 wiring
RJ45 plug pinout is compliant with 10/100 base T, IEEE802.3 Specification. Product is
compliant also with MDI or MDI-X.