User's Manual

MorphoAccess® SIGMA Extreme Series - Installation Guide
Section 3 : Installation Procedure
Identity & Security
2017_2000024418 - Draft
V0
January 2017
This document and the information therein are the property of Safran Identity & Security.
They must not be copied or communicated to a third party without the prior written authorization of Safran
31
Drilling the mounting holes
Be sure that the wall behind the wall plate has a good flatness.
Figure 8: Drilling template
If not present, drill in the wall a hole with a diameter adapted to the width of the
terminal and the cable to be hosted in (see Figure 8: Drilling template. This template
can be found in the Quick Installation Guide).
Confirm the presence inside the hole of all the cables needed for the electrical
installation (see Electrical Interface)
Drill in the wall 6 holes with a diameter adapted to screws and fit them with the raw
plugs (see Figure 8: Drilling template).
1300
mm
40mm min
Φ = 4mm
2
Φ = 4mm
1
Φ = 4mm
4
Φ = 4mm
3
Φ = 4mm
6
Φ = 4mm
5
207,00mm
97,50mm
82,00mm
Ø44,00mm
65,50mm