User's Manual

MorphoAccess® SIGMA Lite Series – Installation Guide
Section 4 : Electrical Interface
2015_2000007248-V1 - Draft
This document and the information therein are the property of Morpho. They must not be
copied or communicated to a third party without the prior written authorization of Morpho
32
June 2015
Output Relay
Figure 11: Output relay wiring
19
Yellow
Relay NO
Contact relay (normally open)
22
Grey
Relay COM
Contact relay common
21
Orange
Relay NC
Contact relay (normally closed)
Nominal characteristics of relay
Load characteristics:
 1 A max @ 30 VDC (according to the safety extra low voltage requirements
independently of the power supply),
 Resistive load or inductive load; see warning information hereafter for inductive
load.
 The internal relay is designed for at least 100 000 cycles.
Inductive load management requires a parallel diode for a better contact
lifetime.