User's Manual

MorphoAccess® SIGMA Lite Series – Installation Guide

Section 3 : Installation Procedure

2015_2000007248-V1 - Draft

This document and the information therein are the property of Morpho. They must not be

copied or communicated to a third party without the prior written authorization of Morpho

June 2015

Installation

Required tools (not supplied)

 Two (2) raw plugs + Two (2) ø 4mm max and length 30mm screws.

 One (1) screwdriver adapted to screws above.

 One (1) Drill (with a drill bit diameter adapted to raw plugs above).

 One (1) hole saw (depending on installation case).

 A (1) Torx T10 screwdriver

 Deadbolt/door strike

 Snubber diode required to protect regulated DC power supply from inductive

kickback (1N4007 diode or equivalent recommended)

 Separate power supply for the deadbolt/door strike based on supplier's

recommendations.

 External relay (if required)

 Networking cable

For UL-294 compliance, an earthed screen in the wire or around all wires to/from

product is only required when the wires share space/compartment/tube with high

voltage cables.

Equipment from the initial package to use

 One (1) Terminal’s body,

 One (1) pre-wired back door,

 One (1) wall plate,

 One (1) Protection accessory (optional) to insert over the biometric sensor