User's Manual

MorphoAccess® SIGMA Lite Series – Installation Guide
Section 2 : General Description
2015_2000007248-V1 - Draft
This document and the information therein are the property of Morpho. They must not be
copied or communicated to a third party without the prior written authorization of Morpho
23
June 2015
Serial port
The serial port supports WIEGAND, DATACLOCK (ISO2) and
RS485 protocols
Output relay switches
Access granted: 1 switch two outputs (normally “open”
and normally “closed”) (30V – 2A max)
USB host port
External port for terminal configuration through a USB
mass storage key
Internal port to connect an external Wi-Fi™ USB dongle
using an adapter cable.
Input signals
LED1/LED2 to activate the access granted relay
Power supply
12 to 24 V DC power supply (1A min @12V)
Or by Power Over Ethernet through RJ-45 connector
Power consumption
TBD
Security of the terminal
Anti-tamper-pulling switches.
Tamper-pulling detection: one relay switch.
Size and weight
W x H x D: 68mm x 156mm x 62mm
(2.68” x 6,14” x 2,44”)
Weight : 280g
Environmental
conditions
Operating temperature -10 °C to + 55 °C (14°F to 131°F)
Operating humidity 10 % < RH < 80 % (non condensing)
Storage temperature -25 °C to + 70 °C (-13°F to 158°F)
Storage humidity 5% < RH < 95 %
IP65 (once back door attached with the 4 screws)
The terminal should be installed in controlled lighting
conditions.
Avoid direct exposure to sunlight or to UV lights.
Certifications
CE, IEC6095-1, FCC Part 15, RSS210, Issue8 : 2010, RoHS,
REACh, WEEE