User's Manual

SSE-0000082427-01 M
ORPHO
DOCUMENT
January 2011
bytes].[additional bits]
app/contactless/data type
Example:
MIFARE™ card Serial Number used as user’s identifier
In this sample the terminal read the first four byte, in MSB direction, of the first sector
of the MIFARE™ card which contains the serial number of the card.
If bytes to read
are
(ASCII).
Activation of identification mode
app/contactless/data format= 1
app/contactless/data type= 0.1
app/contactless/data length = 4.0
app/contactless/data offset= 0.0
app/contactless/B= 1
Example:
32 bits user’s identifier
The user’s
card contains
(which includes
start and stop
Figure 30 : S
ample of user’s identifier which is
The 32 bits
identifier begins at bit four. It is located after the start bit (bit0) and the site
code (bit1-2-
3). The first block of sector #15 is block #46.
Acquisition of a 32 bits user’s identifier inside a 37 bits Wiegand frame
app/contactless/data format= 1
app/contactless/data type= 0.1
MorphoAccess® VP Series
Section 7:
Access control by Authentication
DOCUMENT
. R EPRODUCTION AND D ISCLOSURE P ROHIBITED
bytes].[additional bits]
identifier (15 bytes maximum)
app/contactless/data type
Byte read
acquisition
little or big endian.
0.1 (binary data, MSB first)
0.0 (binary data,
LSB first)
MIFARE™ card Serial Number used as user’s identifier
In this sample the terminal read the first four byte, in MSB direction, of the first sector
of the MIFARE™ card which contains the serial number of the card.
are
F4 E1 65 34, then the user identifier
value
Activation of identification mode
app/contactless/data format= 1
Binary format
app/contactless/data type= 0.1
Binary MSB format
app/contactless/data length = 4.0
Size = 4 bytes, no
additional bit
app/contactless/data offset= 0.0
First byte of the block
app/contactless/B= 1
First block of the card
32 bits user’s identifier
within a 37-bits
Wiegand frame
card contains
, at the first block of sector 15 a full
37 bits Wiegand frame
start and stop
bits, the site code of the sender
, and user’s identifier
ample of user’s identifier which is
included in a
Wiegand frame
identifier begins at bit four. It is located after the start bit (bit0) and the site
3). The first block of sector #15 is block #46.
Acquisition of a 32 bits user’s identifier inside a 37 bits Wiegand frame
app/contactless/data format= 1
Binary format
app/contactless/data type= 0.1
Binary identifier, MSB format
MorphoAccess® VP Series
- User Guide
Access control by Authentication
74
identifier (15 bytes maximum)
acquisition
method: either
0.1 (binary data, MSB first)
LSB first)
MIFARE™ card Serial Number used as user’s identifier
In this sample the terminal read the first four byte, in MSB direction, of the first sector
of the MIFARE™ card which contains the serial number of the card.
value
is "4108412212"
additional bit
First byte of the block
First block of the card
Wiegand frame
37 bits Wiegand frame
, and user’s identifier
).
Wiegand frame
identifier begins at bit four. It is located after the start bit (bit0) and the site
Acquisition of a 32 bits user’s identifier inside a 37 bits Wiegand frame
.
Binary identifier, MSB format