Manual

2: HARDWARE SPECIFICATIONS
2-8 SX5L COMMUNICATION TERMINAL USER’S MANUAL
Digital I/O Modules SX5L-SBM16K1, -SBM16K2, -SBM16S1, -SBM16S2
General Specifications
Digital Input Specifications
Rated Power Voltage 24V DC
Power Voltage Range 21.6 to 26.4V DC (including 5% ripple)
Power Consumption 1.2W (24V DC)
Power Inrush Current 3A maximum (24V DC)
Allowable Momentary Power Interruption 10 ms minimum (at the rated power voltage)
Dielectric Strength 1,000V AC, 1 minute between power and FG terminals
Insulation Resistance 100 MΩ minimum between power and FG terminals (500V DC megger)
Operating Temperature 0 to 55°C (no freezing)
Operating Humidity 30 to 90% RH (non-condensing)
Storage Temperature –20 to +75°C (no freezing)
Storage Humidity 30 to 90% RH (non-condensing)
Pollution Degree 2 (IEC 60664)
Corrosion Immunity Atmosphere free from corrosive gases
Altitude
Operation: 0 to 2,000m
Transport: 0 to 3,000m
Vibration Resistance
10 to 57 Hz amplitude 0.075 mm, 57 to 150 Hz acceleration 9.8 m/s
2
2 hours per axis on each of three mutually perpendicular axes
Shock Resistance 294 m/s
2
, 11-ms sinusoidal half-wave pulse
Mounting 35-mm-wide DIN rail, direct panel mounting (M4 mounting screws)
Weight (approx.) 240g
Type No. SX5L-SBM16K1 / SX5L-SBM16K2 SX5L-SBM16S1 / SX5L-SBM16S2
Input Points 8 points
Input Type
NPN input type
No-voltage input (DC 2-wire sensor, NPN
3-wire sensor, no-voltage contact)
PNP input type
No-voltage input (DC 2-wire sensor, PNP
3-wire sensor, no-voltage contact)
Rated Input Voltage 24V DC
Input Voltage Range 0 to 26.4V DC
Input Impedance Approx. 4.0 kΩ
Input Current 6 mA/point (24V DC)
No. of Common Circuits 1
Input Common Polarity Minus common Plus common
Input Delay Time 250 ms
Input Turn ON Voltage 15V minimum (between input and COM terminals)
Input Turn OFF Voltage 5V maximum (between input and COM terminals)
Input OFF Current 1 mA maximum
Isolation from Power Line Photocoupler isolation
Dielectric Strength
500V AC, 1 minute between input and FG terminals
500V AC, 1 minute between input and power terminals
Insulation Resistance
100 MΩ minimum between input and FG terminals (500V DC megger)
100 MΩ minimum between input and power terminals (500V DC megger)