Datasheet

ManualsBrandsIDEC ManualsRack & DIN Rail Mount PSUsTap terminal 24 Vdc 10 A

PS6R Switching Power Supplies

Accessories (For use with PS6R)

Part No.

DC-DC Converter Unit (Note 5)

Expansion

Terminal Unit

PS9Z-6RM1 PS9Z-6RM2 PS9Z-6RM3 PS9Z-6RM4 PS9Z-6RM5 PS9Z-6RM6 PS9Z-6RS1

Output Capacity 10W max. 12W max. 10W max. 12W max. 11W max. 12W max. —

Output

Rated Voltage/Current 5V/2A 12V/1A ±5V/1A ±15V/0.4A

5V/1A, 12V/0.5A

±12V/0.5A

24V/10A max.

(Note 1)

Adjustable Voltage

Range

Not available

Voltage Accuracy ±5% max. —

Start Time (Note 6) 200 ms max. (at rated output) —

Regulation

Input Fluctuation 0.5% max.

—

Load Fluctuation 1.0% max.

Temperature

Change

0.05%/max. (–10 to +60°C)

Ripple (including

noise)

100mV max. 150mV max. 100mV max. 150mV max.

100mV max.,

150mV max.

Supple-

mentary

Functions

Overcurrent Protection 105% (auto reset)

—

Overvoltage Protection Output off at 120% (Note 2)

Operating Temperature –10 to +70°C (no freezing) (Note 3)

Operating Humidity 20 to 90%RH (no condensation)

Storage Temperature –25 to +75°C (no freezing)

Storage Humidity 20 to 90% RH (no condensation)

Vibration Resistance 10 to 55 Hz, amplitude 0.375 mm, 2 hours each in 3 axes, 6 directions (in combination with PS6R-F24/G24/J24)

Shock Resistance

300 m/s

(150 m/s

when using a PS9Z-6R1F panel mounting bracket),

3 times each in 6 directions (in combination with PS6R-F24/G24/J24)

EMC

EMI EN61204-3 (Class B) (in combination with PS6R-F24/G24/J24) (Note 4)

—

EMS EN61204-3 (industrial) (in combination with PS6R-F24/G24/J24) (Note 4)

Safety Standards UL508 (Listing), CSA C22.2 No.107.1, IEC/EN60950-1, EN50178 (in combination with PS6R-F24/G24/J24)

Degree of Protection IP20 (IEC 60529)

Weight (approx.) 90g 30g

Terminal Screw M3.5

Note 1: Ensure that the current does not exceed the rated current of the PS6R.

Note 2: Repair is needed when output drops due to overvoltage protection. Contact IDEC.

Note 3: For output derating curves and operating temperature approved by safety standards, see page 7.

Note 4: When using PS6R-F24/G24 with PS9Z-6RM3/6RM4/6RM6, coil each output lines of PS9Z-* around a ferrite core for one turn.

Note 5: DC-DC converter unit is non-isolated and cannot be used when insulation against PS6R output is required.

Note 6: Because each output has different start time on multi-output models, make sure of the correct operation before installation.

(13/11/08)