Datasheet

11
PS5R-V Switching Power Supplies
Installing the Panel Mounting Bracket






Latch
Latch
LOCK
LOCK
Panel Mounting Bracket (PS9Z-5R1)
Panel Mounting Bracket (PS9Z-5R2B)
Power
Supply
Power
Supply
Tab
Tab
Slot


<Installing PS9Z-5R1 Panel Mounting Bracket>
<Installing PS9Z-5R2B Panel Mounting Bracket>
LOCK
UNLOCK
LOCK
UNLOCK

Push in the latch to LOCK
position.
 Install the tab on the panel
mounting bracket into the
slot on the power supply.
 Install the brackets as
shown on the left.
 Ensure that the panel
mounting bracket is locked
by the latch.
 Pull out the latch to
UNLOCK position.
 Insert the tab on the panel
mounting bracket into the
slot on the power supply.
 Push in the latch to LOCK
position.
 Ensure that the panel
mounting bracket is locked
by the latch.
Installing PS9Z-6R2F Side-mount Panel Mounting
Bracket
Install the bracket on the switching power supply using four M3 × 6 coun-
tersunk screws supplied with the bracket.
Adjustment of Output Voltage
The output voltage can be adjusted within ±10% of the rated output
voltage (PS5R-VE: ±5%) by using the VR.ADJ control on the front. Turning
the VR.ADJ clockwise increases the output voltage. Turning the VR.ADJ
counterclockwise decreases the output voltage.
Overcurrent Protection
The output voltage drops automatically when an overcurrent ows due to
an overload or short circuit. Normal voltage is auto matically restored when
the load returns to normal conditions.
Insulation/Dielectric Test
When performing an insulation/dielectric test, short-circuit the input (be-
tween L and N) and output (between +V and –V). Do not apply or interrupt
the voltage quickly, otherwise surge volt ages may be generated and the
PS5R-V may be damaged.
Notes for Operation
•Output interruption may indicate blown fuses. Contact IDEC.
•The PS5R-V switching power supply contains an internal fuse for AC input.
When using with DC input, install an exter nal fuse for DC input. To avoid
blown fuses, select a fuse in consideration of the rated current of the in-
ternal fuse.
Rated Current of Internal Fuses
Part No.
Internal Fuse
Rated Current
PS5R-VB/VC 2A
PS5R-VD/VE/VF 4A
PS5R-VG 6.3A
•Avoid overload and short-circuit for a long period of time, oth erwise the
internal elements may be damaged.
•DC input operation is not subject to safety standards.
Rust and Scratches on Metal parts
Hot-dip galvanized steel and bonderized steel are used for the PS5R-V. Rust
on the edge and scratches on the surfaces may be developed depending on
the storage condition, but the performance of the PS5R-V is not affected.
Noise
Small acoustic noise inside the PS5R-V may be heard depending on the
input voltage and load, but the performance of the PS5R-V is not affected.
Operating Instructions