Datasheet

MW Series Control Units
ø22
Instructions
Panel Mounting
1. Remove the locking ring and the anti-
rotation ring, and insert the unit into the
panel cut-out.
ON OFF ON
Nameplate
Incorrect Correct
Rubber
Boot
Panel Front Surface
Housing
Panel
Anti-rotation
Ring
Locking Ring
2. After inserting the unit, install the anti-rota-
tion ring and the locking ring to the housing
in this sequence.
Note: Be careful about orientation of the
anti-rotation ring.
(Note)
Notes on Panel Mounting
When mounting the operator onto a panel,
use the optional locking ring wrench
(MW9Z-T1) to tighten the locking ring.
Tightening torque must not exceed 4.0 N·m.
Do not use pliers. Excessive tightening will
damage the locking ring. Recommended
tightening torque: 2 to 4 N·m
Other Notes
Installing Nameplate
Do not install a nameplate between the
panel front surface and the rubber boot. If
a nameplate of this type is installed, then
the degree of protection will be degraded.
Directly attach a nameplate to the panel
surface.
Oil-proof Characteristics
The oil-proof rating of the MW series unit
is intended for general-purpose coolant oil.
The MW series unit may not be used for
certain oils. Contact IDEC for more infor-
mation.
Notes on Wiring
Solder the terminal at 350°C within 3
seconds, using a 60W soldering iron.
Sn-Ag-Cu solder is recommended. When
soldering, do not touch the switch housing
with the soldering iron. Also ensure that no
tensile force is applied to the terminals. Do
not bend the terminals or apply excessive
force to the terminals. Use a non-corrosive
rosin ux.
Safety Precautions
• Turn off power to the switch before installation, removal, wiring, maintenance, and inspection. Failure to turn power off
may cause electrical shocks or re hazard.
• For wiring, use wires of proper size to meet the voltage and current requirements. Tighten the M3.5 terminal screws of
the screw terminal socket to a tightening torque of 1.0 to 1.3 N·m. If the terminal screw is incompletely soldered or loose,
the terminal may heat up, causing a re.
Maintenance Parts
Name/Shape Specications Part No. Ordering No.
Package
Quantity
Remarks
Button
For ush ABS1BN-* ABS1BN-*PN05 10
Specify a color code in place of * in the Ordering No.
B (Black), G (Green), R (Red), S (Blue),
W (White), Y (Yellow)
For
mushroom
MW9Z-B13* MW9Z-B13*PN02 10
Specify a color code in place of * in the Ordering No.
B (Black), G (Green), R (Red), Y (Yellow)
Color Insert
For selector HA9Z-HC1* HA9Z-HC1*PN05 5
Specify a color code in place of * in the Ordering No.
G (Green), R (Red), S (Blue), W (White),
Y (Yellow)
Locking Ring
Metal MW9Z-LN MW9Z-LN 1 —
Benelux B
Benelux NL
France
Germany-Munich
Germany-Hamburg
Italy
Sweden
United Kingdom
www.apem-idec.eu
([phone] - [e-mail]
(+31) (70) 799 91 51 - [e-mail]
([phone] - [e-mail]
([phone] - [e-mail]
([phone] - [e-mail]
([phone] - [e-mail]
([phone] - [e-mail]
([phone] - [e-mail]