Datasheet

Download catalogs and CAD from http://apac.idec.com
B-132
APEM
Switches &
Pilot Lights
Control Boxes
Emergency
Stop Switches
Enabling
Switches
Safety Products
Explosion Proof
Terminal Blocks
Relays & Sockets
Circuit
Protectors
Power Supplies
LED Illumination
Controllers
Operator
Interfaces
Sensors
AUTO-ID
Switches & Pilot Lights
Flush Silhouette
ø16
ø22
ø30
Miniature
Pilot Lights
CW
LW-F
LB
LBW
UP
Flush Bezel
LB/LBW Series
Panel Mounting
Remove the contact block from the operator. Insert the operator into
the panel cut-out from the front, then install the contact block to the
operator.
(For Standard Bezel)
TOP
TOP
Panel
➀
➁
Anti-rotation Ring
Locking Ring
➂ Contact Bloc
k
(For Flush Bezel)
TOP
TOP
Panel Thickness: 0.5 to 6 mm
Panel
➀ Anti-rotation Ring
➁ Locking Ring
➂ Contact Bloc
k
Notes on Mounting
Use the optional ring wrench (MT-001) to mount the operator onto the
panel. The recommended tightening torque is 0.5 to 0.7 N·m. Do not
use pliers. Excessive tightening will damage the locking ring.
Replacing the Lens and Marking Plate
Removing
[Removing the operator]
Standard Bezel
1) From the opposite side of the TOP marking, remove the operator
(lens, marking plate, and lens holder) using the optional lens removal
tool (MT-101) by gripping the recesses of the color lens.
Flush Bezel
1) From the opposite side of the TOP marking, push the tip (width: 3
mm, thickness: 0.5 mm) of the flat screwdriver to the groove of the
color lens and pull out the operator (lens, marking plate, lens holder).
Note: For metallic bezels, the bezel may be damaged if the screwdriver is
inserted from the TOP side or inserted deeply or with force into the groove
of the lens.
Remove from the
opposite side of the
TOP marking
TOP
[Removing the Operator]
2) Remove the marking plate by pushing the lens from the rear to
disengage the latches between the lens and holder, using the
screwdriver as shown below.
Note: The translucent in the lens holder cannot be removed because this lter is
sealed to make the unit waterproof and oiltight.
LBW Series Pushbutton (button style)
LBW series pushbuttons (button style, see B-097) can be removed
according to the following procedure. LBW series pushbuttons (button
style) cannot be removed from the front of the panel.
[Removing the Operator]
1) Detach the operator unit and contact block. (See Removing and
Installing the Contact Block on B-131 )
2) Remove the button unit (button, button holder) by pushing out the
cross-shaped protrusion (white) at the back of the operator with a
screwdriver.
LBW Series Illuminated Pushbutton (round extended)
Screw-in lens. The lens can be removed by turning anticlockwise.
Push out the cross-shaped protrusion (white)
from the back of the operator unit.
Instructions
Download catalogs and CAD from http://eu.idec.com/downloads