Datasheet

Safety Switch
All dimensions in mm.
The size is greatly reduced while achieving the same 1400N (Fzh) locking
strength as the conventional HS5E series. (GS-ET-19)
Compact with powerful 1400N locking strength
Head removal detection circuitry is employed in the HS5L. With this innovative
function, the monitor circuit (41-42) turns off when the head is removed from
the switch, such as when removing the head to change the head direction
(applicable with the HS5L spring lock models). For example, for circuit codes:
VB, VD and DD, which have two or more lock monitor circuits installed,
removing the head results in disparity (41-42: OFF, 51-52: ON).
This disparity is detected by the head removal detection function.
e
c
t
i
o
n
c
i
r
c
u
i
t
r
y
i
s
e
m
p
l
o
y
e
d
i
n
t
h
e
H
S
5
L
W
i
t
Head Removal Detection Circuitry
Door lock can be unlocked inside the
barrier by a worker left inside a
hazardous area.
A new addition to angle adjustable
actuator. Retention force of 1400N.
Rear unlocking button
Angle Adjustable Actuator
(vertical/horizontal) with Plate
Approx.
13%
shorter
(Compared with IDEC products)
127
145.7
HS5L
Conventional Model
HS5E
Spring clamp terminals
Spring clamp terminals offer
excellent vibration resistance,
preventing wires from
loosening. No need for
additional tightening.
Energy saving!
Solenoid energy
consumption: 200mA
Reduced by 25% from
conventional HS5E series.
Actuator
unlocked
OFF ON
OFF ON
OFF
ON
Note: Head removal detection function is not a direct opening action mechanism.
Actuator unlocked Actuator locked Head removed
● HS5L-VD44M-G (Locｋ monitor circuit)
5251
41
Lock monitor circuit
Lock monitor circuit
42
A1
A2
(+) (–)
Rear unlocking
button
Rear unlocking
button kit for
frames
Wiring port
Wiring port
Driver port
Driver port
Head removal
detection function
Monitor circuit
(41-42)
Disparity
Size is reduced by 13% from conventional models.
∗
Mounts on small doors and aluminum frames of machines.
Compact design with 2- and 4-contacts reduce installation space.
Greater exibility in machine design.
2-Contact
4-Contact
Interlock Switch
IDEC ensures reliability
and performance.
2-contact and 4-contact interlock
switches with solenoid.
Compact Design
Two-conduit Model
Cable can be connected to the
right, left, or bottom (for straight
cable orientation) of the terminal
cover. Possible to use long marking
tubes with the wiring cables.
∗
Except two-conduit
model
Left cable orientation
Straight cable orientation
Right cable orientation
266mA
200mA
Approx.
25%
reduced
(Compared with IDEC products)
HS5L
Conventional Model
HS5E
5