User guide

Chapter 2
78
External Device Setup Manual
2.3.4 Connection Diagram 4: PLC, 2-port Adapter to MICRO/I
There is no pin number corresponding to TERM on the HG2G-S/-5S/-5F, HG3G/4G. When inserting a termination resistor,
use a communication switch. For the setting of the switch, refer to Appendix "3 Important Points Regarding Wiring" on
page 19.
D-sub, 25P connector socket type (unit side) D-sub, 9P connector plug type
D-sub, 25P connector socket type (unit side) Terminal