User guide

49
1 IDEC
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
Connection to a PLC
External Device Setup Manual
1.4 Environment Settings
1.4.1 OpenNet Controller and MICROSmart
When connecting an OpenNet Controller to the MICRO/I, you must set the OpenNet Controller special Internal Relay
M8014 to on.
1.4.2 OpenNet Controller, MICROSmart/MICROSmart Pentra (uses Web Server Unit)
Set the following items on Project Settings dialog box.
Item Setting
Baud Rate (bps) 9600
Data Bits (bits) 7
Parity Even
Stop Bits 1
Network Number
*1
*1. Set a decimal number for the Network Number.
0(DEC)
Item Setting
IP Address (MICRO/I) Set the IP address for MICRO/I.
(Set this item in Communication Interface tab.)
Subnet Mask Set the subnet mask for MICRO/I.
(Set this item in Communication Interface tab.)
Default Gateway Set the default gateway for MICRO/I.
(Set this item in Communication Interface tab.)
IP Address (Web Server Unit) Set the IP address for Web Server Unit.
(Set this item in Host I/F Network tab.)
Port Number (Web Server Unit) Set the port number for Web Server Unit.
(Set this item in Host I/F Network tab.)
- When connecting an OpenNet Controller to the MICRO/I, you must set the OpenNet Controller special Internal Relay
M8014 to on.
- If the HG3F/4F is connected to the IDEC Web Sever Unit, the communication speed of the Web Sever Unit (Ethernet)
must be set to “10 Base” or “Auto”.