User guide

Chapter 2
468
External Device Setup Manual
18.4.3 MICREX-F Interface Card/ Module
Refer to the MICREX-F user’s manual for the details of communication setting
Items Details
Interface RS232C RS485 4-wire
Operation Modes
*1
*1. Set up the mode switch of Interface Card/Module as below.
RS232C:Mode switch is No.1.
RS485: Mode switch is No.3.
Command-setting-type start-stop synchronization non sequenced
format
Baud Rate (bps) Use the same
settings as for the MICRO/I.
1200/2400/4800/9600/19200/38400/57600/115200
Data Bits
7/8
*2
*2. Set Character configuration switch to the following.
Stop Bits
1/2
*2
Parity
None/Odd/Even
*2
Flow Control None/Hardware
Station Number 0 0 – 99(DEC)
Switch Number Configuration
8 Clear method By switch
7 Parity bit ON/OFF Same as MICRO/I
6 Parity bit Odd/Even Same as MICRO/I
5 Data bit Same as MICRO/I
4 Stop bit Same as MICRO/I