User guide

443
18 FUJI
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
Connection to a PLC
External Device Setup Manual
18.3 Connection Diagram
The connector types given in the Connection Diagrams are for the unit and not the cable. For details regarding wiring, refer
to Chapter 1 "3 Important Points Regarding Wiring" on page 19.
18.3.1 Connection Diagram 1: FLEX-PC series (Loader Port) - MICRO/I
There is no pin number corresponding to TERM on the HG2G-S/-5S/-5F, HG3G/4G. When inserting a termination resistor,
use a communication switch. For the setting of the switch, refer to Chapter 1 "3 Important Points Regarding Wiring" on
page 19.
Modular jack 8 Pin D-sub, 9P connector plug type
Modular jack 8 Pin Terminal