User guide

Chapter 2
150
External Device Setup Manual
3.4 Environment Settings
3.4.1 PLC Link Unit Settings
Perform the settings using the rotary switches and DIP switches on the Link Unit.
Item Setting
Interface RS232C RS485
Transmission Control Protocol 1:N
Command Level Levels 1, 2 and 3 are valid
Baud Rate Use the same
settings as for the
MICRO/I.
1200, 2400, 4800, 9600 or 19200
Transmission Code 7 or 8 bit ASCII
Stop Bits 1 or 2
Unit No.
*1
*1. Set a decimal number for the Unit No.
0 to 31(DEC)
Parity Even or Odd
CTS Switch 0V (always on)
Synchronization Switch Internal
Termination Resistor ---------- Yes
- Refer to the Link Unit manual for details.
- Select using Register Command or not in Project Settings - Host I/F Driver.