Manual

5 HG3F/4F
34-68 WindO/I-NV2 User’s Manual
4 Remove the backlight connector from the inverter module.
5 Draw out the backlight , pushing the tab of backlight omission prevention.
6 Connect the replacement backlight by following the procedure in step 5 in reverse.
7 Follow the procedure in step 4 in reverse to connect the connector, then follow the procedure in step 3 in reverse to
stick an attached protection film.
8 Follow the procedure in step 2 in reverse to front and rear cases, then tighten the screws at the rear panel (torque:
0.5 N•m to 0.6 N•m)
HG4F
1 Turn off the power to the HG4F, and disconnect the power supply cable.
2 Remove the screws from the main unit rear panel, and carefully separate the rear case from the front case.
Lift window to remove backlight