User Manual

Programming IDEC SmartRelay
IDEC SmartRelay Manual 97
7. Enter your password.
8. Press OK. Th
e circuit program and the password are
deleted.
Note
In case that you forget the password, you can delete the circuit
program and the password using WindLGC. See the onlinehelp for
WindLGC for more details.
For a base module with versions 3 and earlier, you can delete the
circuit program and the password by inputting a wrong password on
“Clear Prg” menu three times in a row.
For a base module with versions 4 or later, you can delete the circuit
program and the password by inputting a wrong password on
“Clear Prg” menu a hundred times in a row.
3.6.14 Summertime/wintertime conversion
You can enable or disable automatic summertime/wintertime
conversion
• in parameter assignment mode
by calling the “Set..”
menu command
• in programming mode
by calling the “Setup” menu
command.
To enable/disable automatic S/W Time conversion in
progr
amming mode:
1. Switch IDEC SmartRelay to programming mode.
2. You are now in the main menu and want to select the
’Setup’ men
u command: Press
or
3. Confirm ’Setup’: Press OK
4. Move the ’>’ cursor to ’Clock’:
Press or
5. Confirm ’Clock’: Press OK
6. Move the ’>’ cursor to ’S/W Time’:
Press or
7. Confirm ’S/W Time’: Press OK
IDEC SmartRelay shows the following display:
>On
Off
S/W Time:
Off
The current setting of automatic S/W Time conversion is
shown on the bottom row. The default setting is ’Off’:
disabled.