User Manual

Programming IDEC SmartRelay
92 IDEC SmartRelay Manual
3.6.8 Deleting a block
Let us assume you want to delete the block B2 from your
circuit program and connect B1 directly to Q1.
Q1
I1
I2
x
x
Par
B1
B2
Proceed as follows:
1. Switch IDEC SmartRelay to programming mode
(as a reminder, refer to Page 66).
2. Select ’Edit’:
Press or
3. Confirm ’Edit’: Press OK
(If required, enter your password and confirm with OK.)
4. Select ’Edit Prg’:
Press or
5. Confirm ’Edit Prg’: Press OK
6. Move the cursor to B2, the input of Q1 Press
:
B2 Q1
7. Confirm with OK.
8. Now replace block B2 with block B1 at output Q1. The
p
rocedure:
- Select the BN
list: Press or
- Accept the BN list: Press OK
-SelectB1’:
Press or
- Apply ’B1’: Press OK
Result:
Block B2 is deleted, because it is no longer used in
the circuit. Block B1 has replaced B2 directly at the output.