Owner manual
LONWORKS® Communication Module User’s Manual 2-3
2.2 Wiring the LONWORKS® Communication
Module
To wire the LONWORKS® Communication Module, use a
screwdriver with 3 mm wide blade.
- You do not need to use wire end ferrules when clamping
the wires.
NOTE
After the installation, the terminals must be covered. To
protect personnel against unintentional contact with the
portions of the L
ONWORKS® Communication Module that
are conducting electricity, the appropriate national and local
standards must be observed.
The L
ONWORKS® Communication Module is a double-
insulated switching device.
A protective grounding conductor is not necessary.