Datasheet

For more information, visit http://asia.idec.com
B-383
APEM
Switches &
Pilot Lights
Control Boxes
Emergency
Stop Switches
Enabling
Switches
Safety Products
Explosion Proof
Terminal Blocks
Relays & Sockets
Circuit
Protectors
Power Supplies
LED Illumination
Controllers
Operator
Interfaces
Sensors
AUTO-ID
Switches & Pilot Lights
Flush Silhouette
ø16
ø22
ø30
Miniature
Pilot Lights
HW1Z
AP22
A Series
LD6A
ø12 A2 / ø10 A1 / ø8 A8 Series Miniature Pilot Lights
Download catalogs and CAD from http://asia.idec.com/downloads
www.apem-idec.eu
Shape Material Part No.
Ordering
Part No.
Package
Quantity
Remarks
Locking Ring Wrench
Metal
(nickel-plated brass)
MT-002 MT-002 1
• Used to tighten the locking ring when installing the
A2 series into a panel.
Switch Guard
90° open
For round/
square unit
AL-K2 AL-K2 1
• Degree of protection: IP40
• Used to protect pushbuttons
from inadvertent operation.
• See B-384 for dimensions.
(remains 90° open)
For rectangular
unit
AL-KH2 AL-KH2 1
Socket
Solder Terminal AL-C2 AL-C2 1
• Snaps on the rear of the A2 series.
(see B-384 for dimensions)
PC Board Terminal AL-C2V AL-C2V 1
Socket with Built-in Resistor
Solder
Terminal
5V DC AL-C21 AL-C21 1
Socket Bottom Color
Blue
• A current limiting resistor is
contained, eliminating the need for
external resistors.
• When using the socket with a
built-in resistor, make sure that the
continuous current is 1A maximum
and the operating temperature
is –25 to +40°C. In collective
mounting, keep center-to center-
spacing of 20 mm or more between
adjacent units in consideration of
built-in resistor heating.
• See B-384 for dimensions.
6V DC AL-C22 AL-C22 1 Green
12V DC AL-C23 AL-C23 1 Yellow
24V DC AL-C24 AL-C24 1 Red
PC Board
Terminal
5V DC AL-C21V AL-C21V 1 Blue
6V DC AL-C22V AL-C22V 1 Green
12V DC AL-C23V AL-C23V 1 Yellow
24V DC AL-C24V AL-C24V 1 Red
Terminal Cover
Nylon AL-V2 AL-V2PN10 10
• When wiring the terminals, insert the lead wires
into the terminal cover holes before soldering.
• Terminal cover is not attached and must be
ordered separately.
Dust Cover
➀ ➁ ➂
➀
For round units
AL-D2 AL-D2 1
• When mounting the units with the dust covers
installed, refer to mounting hole layout on B-384.
• Operating temperature: –10 to +55°C
• Material
Front part: Elastomer (transparent)
Rear part: Polypropylene (black)
• See B-384 for dimensions and mounting hole
layout.
➁
For square units
AL-DQ2 AL-DQ2 1
➂
For rectangular units
AL-DH2 AL-DH2 1
Mounting Hole Plug
Nitryl rubber (black) AL-B2 AL-B2PN05 5 • Degree of protection: IP65
60
ø14
ø12 A2 Series Accessories All dimensions in mm.