Datasheet

For more information, visit http://asia.idec.com
B-167
APEM
Switches &
Pilot Lights
Control Boxes
Emergency
Stop Switches
Enabling
Switches
Safety Products
Explosion Proof
Terminal Blocks
Relays & Sockets
Circuit
Protectors
Power Supplies
LED Illumination
Controllers
Operator
Interfaces
Sensors
AUTO-ID
Switches & Pilot Lights
Flush Silhouette
ø16
ø22
ø30
Miniature
Pilot Lights
LB
A6
ø16 A6 Series Miniature Switches and Pilot Lights
www.apem-idec.eu
Opening/closing the Switch Guard
(LB9Z-K2, LB9Z-K3P)
When opening/closing the switch guard while the switch guard is not
installed on a panel, make sure to hold the hinge. Holding the base
might result in damage. Also do not apply force on the guard in other
than open/close directions, otherwise the hinge may be damaged.
Hinge
Base
Operating Voltage of LED Lamps
The operating voltage of 5V DC is measured at complete DC.
Other Notes
Close Proximity Mounting
When mounting pilot lights or illuminated pushbuttons collectively or
lighting them continuously, heat may cause the ambient temperature
to rise above the rated operating temperature. When the mounting
panel is not made of metal or when the control units are mounted in an
enclosed panel, provide for ventilation or lower the operating voltage.
Replacement of Buttons (Illuminated/Non-illuminated)
Do not replace buttons of maintained action units while the button is
in the locked position. Replacing the button in the locked position may
damage the internal mechanism. Be sure to release the button before
replacing.
Operating and Storage Environment
1. Make sure that the operating/storage temperature and humidity are
within the ratings.
2. Do not use enclosed type units in an environment subject to oil,
water or dust accumulation. In such an area, use the waterproof/
oiltight units (IP65).
Microswitch Contacts
Do not connect NO and NC contacts of a microswitch to different
voltages or different power sources to prevent a dead short-circuit.
IP65 Units
IP65 units are evaluated by conventional cutting and cooling oils, and
can not be used with some special oils. Contact IDEC for resistance
against specific oils.
Selector Switches with Key
Observe the following instructions to prevent malfunction or damage.
• Insert the key to the bottom of the key hole.
• Do not remove the key from any key retained position.
• Besides the standard key (key number 0H), six other key numbers are
available. Use a key of the matching number with the key cylinder.
The standard key does not have a key number indication.
Operating Instructions
All dimensions in mm.