Instructions / Assembly

iDEAL Paint Spray Booth (PSB-SDD26B-AK)

5.3 EVERY TWO MONTHS

5.3.1 Lubricate Door Latches

Lubricate bearing pin and laminated cam with SAE 30-50 high temperature oil. Tighten set screws in handle as needed.

For use in cold areas, use SAE 10-20 high temperature oil.

Test explosion-venting feature to verify proper operation. Corrosion and/or build-up of foreign materials may affect

proper operation of latches.

5.4 EVERY SIX MONTHS

5.4.1 Check Fan Belts

1. The fan sheave (A) and motor sheave (B) must be

inaxial alignment. Shafts must be parallel in both

vertical and horizontal planes.

2. The sheaves must be in radial alignment. When

sheaves are of equal width, align with a straight edge

(C). When sheaves are of unequal width, align

centerof sheaves.

3. Check fan belts for proper tension and for signs of

wear. Belt should have a slight sag at bottom

ofsheaves. Belt (D) is properly adjusted. Belt (E) is too

loose. Belt (F) is too tight.

5.5 EVERY YEAR

5.5.1 Inspect Motor

Verify that cooling air to motor has not been diverted or

blocked by dirty guards or other obstacles.

5.5.2 Inspect Fan Wheel

Inspect fan wheel for buildup of material, which may cause an

unbalanced fan wheel. An unbalance fan wheelmay lead to

premature failure of the fan wheel, bearings, and belt. Clean

material buildup as necessary.

5.5.3 Inspect And Clean Air Solenoid Valve

The function of this valve is to interrupt the supply of compressed air to the painting equipment when the booth is not

operating as designed or if any booth doors are open.

The time between cleanings varies depending on the medium and service conditions. If voltage to coil is correct, sluggish

valve operation, excessive noise or leakage indicates that cleaning is required. Close strainer or filter when cleaning

valve. Thoroughly clean all parts. If parts are worn or damaged, install a complete rebuild kit. Follow instructions

included with rebuild kit.