Instructions / Assembly

iDEAL Paint Spray Booth (PSB-SDD26B-AK)

Install Door Sweeps

1. Cut a piece of rubber sweep material long enough to fit the bottom width of the product door.

2. Place cut piece of rubber on the floor centered under the bottom of the door.

3. Lift the outside edges of the cut rubber up on each side of door so it forms a loop that touches the floor.

4. Mark the position of the top edge of the cut rubber on each side of the door.

5. Hold one edge of the cut rubber on the mark on one side of the door and place a hold down strip on it.

Screw the strip and rubber to the door.

6. Repeat step 5 on opposite side of door.

7. Repeat above on the remaining doors.

4.13 ACCESS DOOR LIMIT SWITCH INSTALLATION

1. Screw limit switch to limit switch mounting plate (may be mounted on right or left plate) so actuating arm

aligns with door edge.

2. Adjust actuating arm so trigger plate will actuate switch.

3. Attach trigger plate to door edge so it actuates switch.

4. Make final adjustments to lever arm to assure proper operation and tighten set screw on limit switch lever.

4.14 ACCESS DOOR LATCH INSTALLATION

1. Attach striker to top edge of door so it will actuate roller in latch.

2. Attach latch to plate so it is actuated by striker.

Limit

Switch

Door Latch Assy

Door Striker

Bracket