Instructions / Assembly

iDEAL Paint Spray Booth (PSB-SDD26B-AK)

4.10 TUBEAXIAL FAN

The fan and motor assembly can bolt to the top of Chimney Exhaust Stacks, or it can be placed in the

exhaust duct above the roof (optional mounting flange rings required)

4.11 OPTIONAL - EXHAUST DUCT KIT &INSTALLATION

If equipped with optional exhaust ductwork, it is recommended to

save this professionally installed.

(Storm Collar & Roof Flange sold separately)

To assemble the ductwork:

1. Bolt pipe with connecting ring to the exhaust fan.

2. Remaining ductwork is crimped on one end to interlock with

the nextsection.

3. Your ARV (automatic damper) will be mounted on top.

4. Storm collar will attach to duct above flashing to make it

weatherproof.

Special Note:

Where more than 25 ft. of piping is required, static pressure

(resistance) isincreased and the air flow may be hindered when using

the standard exhaustunit recommended for use with the

booth.Where a piping arrangement of an unusual nature is necessary

or where twoor more elbows are used, a similar condition may exist.

Therefore, if either ofthese situations arises, contact the iDEAL for

recommendations. Exhaust piping, including the canopy (if used),

should extend a minimum of6’ ft. above the highest point of

building. There should be an access door justabove exhaust unit and

another just below each elbow.