Instructions / Assembly

iDEAL Paint Spray Booth (PSB-SDD26B-AK)

4.9.3 Electrical

Complete booth assembly and then perform steps 1-4 below to connect electrical service to motor

(NOTE: iDEAL does not recommend using 120V single phase on motors above 1HP)

1. Determine voltage at your facility.

2. If a control panel was sent with this booth, confirm that the voltage and phase on thecontrol panel matches the

voltage and phase you intend to use.

3. Ensure the wiring diagram belowmatches your voltage, phase, and HP.

4. Locate the rotation arrow on the fan and verify belts are rotating in the direction of the arrow. If the belts are

not rotating in the direction of the arrow, reverse the motor.

Motor Wiring Diagram 208-230/460 Volt, 3-Phase, 2 HP