Instructions / Assembly

iDEAL Paint Spray Booth (PSB-SDD26B-AK)

Exhaust Chimney Stack Assembly

1. Screw panel 12x30x48 panel (KF03-001) to 12x30x48 with 1 Tab Down flange (KF03-002).

2. Screw panel 12x30x24 to the other panel 12x30x24 (KF03-003).

3. Place panel 12x30x24 on top of panel 12x30x48 1 Tab Down. Screw them together using 1” tabs.

4. Place the back edges of panel 24x32 (KF03-004) flush on the front of the slant edges of panels

22x24x12L (KF03-006) and 22x24x12R (KF03-007)and clamp together. Screw these panels together along

slanted edges.

5. Place the front edges of panel 22x32 (KF03-005) flush on back edges of panels 22x24x12L (KF03-006)

and 22x24x12R (KF03-007) and clamp together. Screw these panels together along the edges.

6. Place flat bottom face of panel 28x32 (KF03-008) on top of the panels above and screw together.

7. Place the assembly you just made on top of the assembly made in step 3 above with the slanted panel

facing away from the downward tab that is on the bottom assembly. Screw these sections together

using the 1” tabs.

8. Repeat above for second stack on opposite side of the booth.

9. The exhaust stacks are designed to set on top of the side exhaust boxes with the exhaust mounted on

their top flat surface with the hole. These exhaust stacks can be located on the side exhaust box so the

exhaust duct going through the roof will miss any structural beams, pipes etc. You should field cut the

rectangular hole for the exhaust stack so it matches the position where it needs to be. The support

stand is then placed below the exhaust stack to support the weight of the stack, fan and duct work.

KF03-002

KF03-001

KF03-003

KF03-005

KF03-007

KF03-006

KF03-004

KF03-008

NOTE:

Tab Down flange