Instructions / Assembly

iDEAL Paint Spray Booth (PSB-SDD26B-AK)
16
Exhaust Boxes
1. Attach panel (KP33) to exhaust grid side spacer (KP30L).
2. Attach panel (KP33) to exhaust grid side spacer (KP30R) at other end of exhaust grids.
3. Screw flat panel (KP36) over the exhaust grid side spacers (KP32R) and (KP29R) covering the opening.
Repeat on opening at other end of exhaust grids.
4. Place joint splicer (KP37) on inside corner of exhaust box side cover (KP34) with half of it sticking out to
be joined later with exhaust box side cover (KP35).
5. Place joint splicer (KP37) on inside corner of exhaust box side cover (KP35) with half of it sticking out to
be joined later with exhaust box side cover (KP34).
6. Place the (KP34) panel with the joint splicer against the (KP28R) panel and the (KP33) panel. Screw it
flush to these panels.
7. Set the exhaust stack support frame on the floor at the end of the (KP34) where the joint splicer is.
8. Place the (KP35) panel against the (KP31) panel and the (KP37) joint splicer. Screw this panel to these
two panels leaving the exhaust stack support inside of the (KP35) panel.
9. Place the second (KP34) panel against the (KP28L, KP33 and the KP37) joint splicer. Screw this panel to
the three panels.
10. The hole for the exhaust stack will be field located and cut later.
11. Anchor the bottom tabs of panels (KP34) and (KP35) to the floor using 1/4”x1” drive anchors.
12. Repeat above on opposite side of booth.
E
x
h
a
u
s
t
S
t
a
c
k
KP34
KP37
KP35
KP37
KP34
KP28L
KP31
KP28R
KP30L
KP33
KP36
KP32L
KP29L
KF01
KP36
KP33
KP29R
KP30R
KP32R
FIELD NOTCH CUT REQUIRED
FOR T-BAR FLANGES