Instructions / Assembly

iDEAL Paint Spray Booth (PSB-SDD26B-AK)

KC01

KC03

KC04

KC05

Exhaust Filter Grid(s) Installation:

Small ‘End’ Filter Grid Sections

1. Using #8 drill screws screw a 40” angle (KC02) to the top of the opening.

2. Screw a 19-3/4” angle (KC03) to both ends of the opening.

3. Screw a 40” angle (KC02) between the two side angles at the bottom of the opening.

4. Place a 2”x19-3/4”flat strip (KC04) vertically in the center of the opening and screw in place from the

backside of the frame.

5. Place a 2”x40” flat strip (KC06) horizontally in the center of the opening and screw in place from the

backside of the frame.

6. Cut a piece of the roll blanket filter to fit opening and push in place.

Large ‘Center’ Filter Grid Section

1. Using #8 drill screws screw a 100” (KC01) angle to the top of the opening.

2. Screw a 19-3/4” angle (KC03) to both ends of the opening.

3. Screw a 100” angle (KC01) between the two side angles at the bottom of the opening.

4. Place 4 each 2”x19-3/4” flat strips (KC04) vertically on 20” centers in the opening and screw in place

from the backside of the frame.

5. Place a 2”x100” flat strip (KC05) horizontally in the center of the opening and screw in place from the

backside of the frame.

6. Cut a piece of the roll blanket filter to fit opening and push in place.

KC03

KC04

KC06

KC02

BOOTH INSIDE

BOOTH OUTSIDE

BOOTH INSIDE

BOOTH OUTSIDE