Instructions / Assembly

iDEAL Paint Spray Booth (PSB-SDD26B-AK)

KP19

KP17

KC01

KC03

KC01

KC03

KC01

KC17

Intake Filter Grid Installation – Continued (NOTE: 2” side of angle goes up and smaller angle sticks out horizontally)

Large ‘Center’ Filter Grid Section

1. Screw one 99-1/2” angle (KC01) to the 100” side of the intake filter opening using #8 drill screws. Repeat

on opposite side.

2. Screw one 99-1/2“angle (KC01) to the other 100” side of the intake filter opening using #8 drill screws.

Repeat on opposite side of small intake filter opening.

3. Screw four sets of two 99-1/2” angles (KC01) together back to back.

4. Place these sets across the small intake filter opening on 20” centers and screw in place.

5. Screw five sets of two 19-1/2” angles (KC03) together back to back.

6. Place these sets across the 20” opening formed by the sets of 99-1/2” angles on 50” centers and screw

in place. This forms 20”x50” rectangles for intake filters.