Instructions / Assembly

iDEAL Paint Spray Booth (PSB-SDD26B-AK)
13
KP18
KP19
KP16
KC02
KC01
KC03
KC01
KC03
KC01
KC02
KC01
KC16
KC02
KC02
Intake Filter Grid Installation (NOTE: 2” side of angle goes up and smaller angle sticks out horizontally)
Small ‘Ends’ Filter Grid Sections
1. Screw two 40” angles (KC02) to the 80” side of the small intake filter opening using #8 drill screws.
Repeat on opposite side of small intake filter opening.
2. Screw one 99-1/2“angle (KC01) to the 100” side of the small intake filter opening using #8 drill screws.
Repeat on opposite side of small intake filter opening.
3. Screw three sets of two 99-1/2” (KC01) angles together back to back.
4. Place these sets across the small intake filter opening on 20” centers and screw in place.
5. Screw four sets of two 19-1/2” (KC03) angles together back to back.
6. Place these sets across the 20” opening formed by the sets of 99-1/2” angles on 50” centers and screw
in place. This forms 20”x50” rectangles for intake filters.
7. Repeat above in second small opening, after Large Filter Grid is installed.