Instructions / Assembly

iDEAL Paint Spray Booth (PSB-SDD26B-AK)

T-Bar Assembly Detail

Basic Installation - Second Section:

1. Bolt exhaust filter grid side spacer assemblies and the exhaust grid header panel in the bottom of wall panel

beam supports for the first and second sections of the booth. Repeat on opposite side of the booth.

2. Install the ceiling blank cross support panel between the two wall panel beam hip beams.

3. Bolt the next two panels on top of the exhaust grid header panel. Repeat on opposite side of the booth.

4. Install the two hip panels (be sure intake air flat tab is at top of panel).

5. Verify walls are plumb and section is square and on floor layout marks.

6. Install filter grid spacer panels.

7. Square and level all panels shimming from the bottom of the panels. Be sure all joints are plumb and corners

square. Tighten all bolts and nuts as panels are squared and leveled.

8. Anchor panels to floor.

9. Note: If using intake plenum/canopy box, install intake box side panels on top of hip panels, bolting it to the hip.

Install the roof panels on top of the intake plenum/canopy box wall panels.

Basic Installation - Third Section:

1. Bolt exhaust filter grid side spacer assemblies and the exhaust grid header panel in the bottom of wall panel

beam support for the second section of the booth. Repeat on opposite side of the booth.

2. Install the hip support angles on the right and left frontal front wall panels.

3. Bolt the front wall panel at either front corner to one of the side wall panels together and attach these two

panels to the exhaust filter grid side spacer assembly in step 1. Repeat on opposite side.

4. Bolt the next two panels on top of the exhaust grid header panel. Repeat on opposite side of the booth.

5. Install the two hip panels (be sure intake air flat tab is at top of panel).

6. Verify walls are plumb and section is square and on floor layout marks.

7. Install product door side door jambs and cross jamb between the two frontal panels.

8. Place header panel on top of cross door jamb and bolt together.

9. Check product door frame for square and level. Square and level all panels shimming from the bottom of the

panels. Be sure all joints are plumb and corners square. Tighten all bolts and nuts as panels are squared and

leveled.

10. Install filter grid spacer panels.

11. Note: If using intake plenum/canopy box, install intake box side panels on top of hip panels, bolting it to the hip.

Install front panel on top of header panel on top of cross door jamb back wall panel bolting the two side panels

to the front panel on top of header pane panel. Install the roof panels on top of the intake plenum/canopy box

wall panels.

KT-02R

KT03L

KT01L

KT04R

KT01R

KT04L

KT02L

KT03R