Installation Guide

iDEAL Paint Spray Booth (PSB-AFCF23ASY)
20
4.10 TUBEAXIAL FAN
The fan and motor assembly bolts to the top of the Exhaust Chamber Roof Panel
4.11 OPTIONAL - EXHAUST DUCT KIT &INSTALLATION
If equipped with optional exhaust ductwork, it is recommended to
save this professionally installed.
(Storm Collar & Roof Flange sold separately)
To assemble the ductwork:
1. Bolt pipe with connecting ring to the exhaust fan.
2. Remaining ductwork is crimped on one end to interlock with
the nextsection.
3. Your ARV (automatic damper) will be mounted on top.
4. Storm collar will attach to duct above flashing to make it
weather proof.
Special Note:
Where more than 25 ft. of piping is required, static pressure
(resistance) isincreased and the air flow may be hindered when using
the standard exhaust unit recommended for use with the booth.
Where a piping arrangement of an unusual nature is necessary or
where two or more elbows are used, a similar condition may exist.
Therefore, if either ofthese situations arises, contact the iDEAL for
recommendations. Exhaust piping, including the canopy (if used),
should extend a minimum of 6’ ft. above the highest point of
building. There should be an access door just above exhaust unit and
another just below each elbow.