User Guide

14
Battery Replacement
1. Turn the power off and remove the test leads from the clamp
meter.
2. Remove the screws from the back case.
3. Lift and remove the back case.
4. Remove the old battery and insert a new 9V battery.
5. Replace the back case, and secure the case screws.
To Measure Resistance and Continuity
1. Set the rotary switch to .
2. Insert the black lead into the COM port and the red lead into
the port.
3. Connect the test leads to the circuit to be measured
4. Measure resistance.
5. If the resistance is lower than 40Ω, the meter beeps.
General Specifications
Indoor Use
Conductor Size: Cable 55mm (approx.)
Bus Bar 65mm (D) x 24mm (W)
Battery Type: 9V
Display: 3-3/4 LCD with 40 seg. bargraph
Range Selection: Auto and manual
Overload Indication: Left most digit blinks
Power Consumption: 12mA (approx.)
Low battery Indication:
Sampling Time: 2 times/sec. (display)
20 times/sec. (bargraph)
Operating Temperature: 4°C to 50°C
Operating Humitdity: Less than 85% relative
Altitude: Up to 2000M
Storage Temperature: -20°C to 60°C
Storage Humidity: Less than 75% relative
Dimension: 271mm (L) x 112mm (W) x 46mm (H)
10.7” (L) x 4.4” (W) x 1.8” (H)
Weight: 647 g/22.8 oz. (batteries included)
Accessories: Carrying bag x 1
Users manual x 1
9v battery x 1, installed
Options: Thermal couple adapter
K-type thermal couple
Maintenance
13
Warning
To avoid electrial shock, remove test leads before opening the
cover. Repairs or servicing not covered in this manual
should only be performed by qualified personnel.
Warning
Do not touch or adjust any components inside the clamp
when the back case is removed.