User Guide

6
AC Volt
Range Resolution Max Display Accuracy
3V 1mV 3.000 ±(1.3% +5)
40Hz to 500Hz
30V 10mV 30.00 ±(1.3% +5)
300V 100mV 300.0 40Hz to 1kHz
750V 1V 750
AC Conversion Type: Average Sensing RMS indication.
Input Impedance: 10MΩ less tan 100PF.
To Measure True RMS AC Voltage:
1. Plug the black test lead into the COM port and the red test
lead into the VΩHz port.
2. Set the rotary switch to the V position.
3. Push the blue button until AC is shown on the display.
4. Connect the meter in parallel with the load or circuit.
5. Measure AC Voltage.
Overload Protection
Function Overload Protection
VAC & VDC 1000V
AAC & ADC 1A/500V
10A/500V
Ohms (Ω) 600VAC/600VDC
Diode 600VAC/600VDC
Continuity 600VAC/600VDC
Unit of Measure Multipliers
For your reference, the following symbols are often used to
make measurement easier:
Symbol Verbal Multiplier
M mega x 1,000,000
k kilo x 1,000
m milli ÷ 1,000
µ micro ÷ 1,000,000
Auto Power Off (APO)
The APO sign on the LCD panel indicates the meter is working
in the Auto Power Off mode. If the meter idles for more than 10
minutes, the meter automatically turns the power off. When this
happens, the state of the meter is saved the meter can be
turned back on by pushing any key switch or changing the
rotary mode. The meter will give an alarm 15 seconds before
the meter automatically turns the power off. To disable the auto
power off function, power-up the meter while pressing either
the range or Hz switch.
Hz sensitivity
The sensitivity in the Hz mode (pushing key) is 1/10 of full
scale range. The accuracy is same as Frequency mode. The
measuring frequency is from 40Hz up to 1KHz.
APO RPM
Hz
˜
Circuit Connection:
˜
˜
˜
5