Installation Guide

– 3 –
How to Make Back-To-Back Bends
A back-to-back bend produces a “U” shape in a single length of
conduit. Use the same technique for a conduit run across the floor
or ceiling which turns up or down a wall.
Example:
Step 1. After the first 90° bend has been made, measure to
the point where the back of the second bend is to be, “B”.
Step 2. Measure and mark your conduit the same distance,
mark “B”.
Step 3. Align the mark on the conduit with the Star-Point on
the bender and bend to 90°.
Star-Point on bender must be referenced for accurate bends.